How To Add A New Cable

Go to Main > Cable > Cable Maintenance.
Click the button.
Enter a unique Cable Name.
Choose a value on the Cable Type drop-down.
You may optionally enter the Owner, the Length and Signal Loss for the Cable.
Next we are going to specify the capacity of the cable either in terms of pairs or strands, enter the capacity of the
cable by specifying the Low and High Pair/Strands. (center of screen)
Choose the initial Status of the Pairs/Strands for this cable. (Spare, Reserved, Unknown, etc.)
You may optionally choose the Type of cable (Voice or Data) from the Type drop-down.
Choose the equipment the cable pair/strands originate from (note: the pair/strands in an individual cable can originate
from different frames/devices) You may enter the frame/device name or chose it from the picker.
If known you may also specify the destination frame/device for this pair range.
Click the button.

If the destination frame/device is not specified it can be entered later. Any time changes are made here and Save is clicked
the settings will be applied to the specified range of Pairs/Strands.

Any time you access this Cable from this screen you will get a summary section to give you an overview of the Cable.

.Add New Cable v2020.3

.Add New Cable v2.1.4.7

Browser not supported