...
Required
Datatype is String.
Port/Pin/Len
Required
Datatype is String.
Pair Status
Required
Datatype is String.
Permitted values are from the PAIR_STATUS List Values : Left In, Spare, Assigned, Reserved, PDPC, Pending Disconnect, Pending Connect, Bad, and Unknown.
Any values added by a User to the PAIR_STATUS list can also be used.
Equipment Location
Datatype is Hierarchical String.
The Equipment Location is only used to find the correct Equipment. It is only needed if there are more than one Equipment with the same Equipment ID in different Locations.
...
Permitted values are from List Values of type LOCATION_TYPE: Site, Building, Floor, Room, Cube, Truck, Closet, Rack, Elevation, or Manhole.
...
User entered values to the LOCATION_TYPE list may also be used.
Pair Status
Required
Datatype is String.
Permitted values are from the PAIR_STATUS List Values : Left In, Spare, Assigned, Reserved, PDPC, Pending Disconnect, Pending Connect, Bad, and Unknown.
Any values added by a User to the PAIR_STATUS list can also be used.
Port/Pin/Len
Datatype is String.
Multiple Paths
Datatype is Boolean.
...
All other values enter as False [0].
Port Side
...
Datatype is String.
Permitted values are from the PORT_SIDE List Values : Front, Back, Cross-Connect, and N/A.
...
Any values added by a User to the PORT_TYPE list can also be used.
Port Speed
Datatype is List.
Default value is blank.
Permitted values are from the PORT_SPEED List Values : 10 Mbps, 100 Mbps, 1 Gbps, Auto, Auto-10, and Auto-10-100.
VLAN
Datatype is String.
Default value is blank.
...
If the VLAN already exists, this is ignored. It will not update.
Port Speed
Datatype is List.
Default value is blank.
Permitted values are from the PORT_SPEED List Values : 10 Mbps, 100 Mbps, 1 Gbps, Auto, Auto-10, and Auto-10-100.
Flags
REPLACE_VLANS
Default value is False
...